|
Posted by spaco on May 30, 2007, 5:18 pm
Please log in for more thread options
A piece of railroad tie sunk into the ground works. Some guys weld a
bracket out from a bench leg and then weld a ring to that which the post
fits into.
My 2 post vises (and 5 other stands I dealt with) are mounted on stands
whose base is a 215 pound New Holland hay baler flywheel (particulars on
demand). One of the holes in the flywheel is just right for the post
vise leg.
Pete Stanaitis
---------------------------------
stans4@prolynx.com wrote:
> I'm missing the floor plate that the vise sockets into, I've never
> seen one at any of the auctions I've been to, so have no Idea of
> external dimensions needed. Could anyone supply same from theirs?
> Off the cuff, I'd say that 6" square was probably too small and a foot
> square maybe a little large. Would a round one be better than a
> square one(no corners to catch on, maybe)? Other than that, the thing
> seems to be in fairly good shape except for the crud on it. Might be
> because of the crud on it that it's in good shape.
>
> Stan
>
| 
XML site map