Tool for ID stamp on blades
NewsGroups | Search | About
Login Password
Register Now! Lost Password?
 alt.crafts.blacksmithing    Post an article   get this group's latest topics as an RSS feed add this group's latest topics to your My MSN content add this group's latest topics to your My Yahoo content
Subject Author Date
Tool for ID stamp on blades R 06-16-2008
Posted by R on June 16, 2008, 8:09 am
Please log in for more thread options
        Good morning to the group. Thanks to all for the input on
etching solutions for my damascus. All is going well. My new question
is can anyone provide me with a source to get a ID or trademark stamp
produced? I would like to stamp my damascus blades with my mark.

Rich Stoops


Posted by Chilla on June 16, 2008, 10:57 am
Please log in for more thread options
Really? Why not just electro etch your logo on? Regards Charles

R wrote:
>         Good morning to the group. Thanks to all for the input on
> etching solutions for my damascus. All is going well. My new question
> is can anyone provide me with a source to get a ID or trademark stamp
> produced? I would like to stamp my damascus blades with my mark.
>
> Rich Stoops


Posted by spaco on June 16, 2008, 4:20 pm
Please log in for more thread options
Buckeye Engraving, www.steelhandstamps.com or 330-677-5685. Their ad
usually shows up in "The Anvil's Ring", quarterly publication of ABANA.

Pete Stanaitis
--------------

R wrote:
>         Good morning to the group. Thanks to all for the input on
> etching solutions for my damascus. All is going well. My new question
> is can anyone provide me with a source to get a ID or trademark stamp
> produced? I would like to stamp my damascus blades with my mark.
>
> Rich Stoops
>

Similar ThreadsPosted
Steel used for lawn mower blades? July 10, 2006, 9:55 am
Making shovel heads 9or blades) with the Roger Lorance Swage Block October 14, 2009, 1:03 am
Tool ID August 25, 2010, 4:47 pm
Mystery tool September 10, 2007, 11:32 am
HSS tool steel April 9, 2005, 3:45 pm
re woodworking tool making questions November 26, 2005, 12:23 pm
Ken-Tool tire-iron (spoon) February 6, 2009, 1:42 am
woodworking tool making questions. November 15, 2005, 9:07 am

The site map in XML format XML site map
 Contact Us | Privacy Policy