dried out glazes

 rec.crafts.pottery    Post an article   get this group's latest topics as an RSS feed add this group's latest topics to your My MSN content add this group's latest topics to your My Yahoo content
Subject Author Date
dried out glazes light.spirited 11-14-2006
Posted by light.spirited on November 14, 2006, 9:58 pm
Please log in for more thread options
Hullo,
I have just got myself a second hand kiln and it came with a few boxes
of glazes. Quite a few of these glazes are completely dried out. Is it
possible to rehydrate them?
Thanks


Posted by Bob Masta on November 15, 2006, 9:05 am
Please log in for more thread options
On 14 Nov 2006 18:58:14 -0800, "light.spirited"

>Hullo,
>I have just got myself a second hand kiln and it came with a few boxes
>of glazes. Quite a few of these glazes are completely dried out. Is it
>possible to rehydrate them?
>Thanks
>

Most glazes are simply water-based suspensions. They should
rehydrate OK, but if they've solidified into a hard cake you may
have to break them up a bit. You'll want to sieve them after
you rehydrate. The idea here is not to block the chunks, it's
to give you a chance to work them around on the top of the
sieve with a brush until they dissolve and pass through.

If you don't have a sieve yet, go down to your supermarket
and but one of those plastic coffee filters. The basket of
the ones I've seen (Ann Arbor, Michigan, USA) are brown,
with a nice taper that just fits into the top of a 16-oz yogurt
tub. The plastic mesh is 110 count, which is actually finer
than you really need (80 or even 60 is probably enough),
but it doesn't hurt... just takes a bit longer to get everything
through.

Having said all that, however, I would caution that you check
these glazes very carefully. If they are really old, they will
almost certainly contain lead. If they are commercial glazes,
you may be able to find out about that from the makers if
you can read the numbers, colors, and types on the jars.
If there is any doubt, I'd err on the side of caution and
take them to the nearest toxic waste pickup station.

Best regards,



Bob Masta
dqatechATdaqartaDOTcom

D A Q A R T A
Data AcQuisition And Real-Time Analysis
www.daqarta.com
Home of DaqGen, the FREEWARE signal generator

Posted by DKat on November 15, 2006, 2:41 pm
Please log in for more thread options

> On 14 Nov 2006 18:58:14 -0800, "light.spirited"
>
>>Hullo,
>>I have just got myself a second hand kiln and it came with a few boxes
>>of glazes. Quite a few of these glazes are completely dried out. Is it
>>possible to rehydrate them?
>>Thanks
>>
>
> Most glazes are simply water-based suspensions. They should
> rehydrate OK, but if they've solidified into a hard cake you may
> have to break them up a bit. You'll want to sieve them after
> you rehydrate. The idea here is not to block the chunks, it's
> to give you a chance to work them around on the top of the
> sieve with a brush until they dissolve and pass through.
>
> If you don't have a sieve yet, go down to your supermarket
> and but one of those plastic coffee filters. The basket of
> the ones I've seen (Ann Arbor, Michigan, USA) are brown,
> with a nice taper that just fits into the top of a 16-oz yogurt
> tub. The plastic mesh is 110 count, which is actually finer
> than you really need (80 or even 60 is probably enough),
> but it doesn't hurt... just takes a bit longer to get everything
> through.
>
> Having said all that, however, I would caution that you check
> these glazes very carefully. If they are really old, they will
> almost certainly contain lead. If they are commercial glazes,
> you may be able to find out about that from the makers if
> you can read the numbers, colors, and types on the jars.
> If there is any doubt, I'd err on the side of caution and
> take them to the nearest toxic waste pickup station.
>
> Best regards,
>
>
>
> Bob Masta
> dqatechATdaqartaDOTcom
>
> D A Q A R T A
> Data AcQuisition And Real-Time Analysis
> www.daqarta.com
> Home of DaqGen, the FREEWARE signal generator

You can heat up your water to make dissolving the material easier (If you
have delicate coloring then use distilled water and heat on the stove - I
just take it hot out of the pipes but I have good water). If the glazes are
clearly labeled and you know the ingredients



Posted by DKat on November 15, 2006, 2:57 pm
Please log in for more thread options

>
>> On 14 Nov 2006 18:58:14 -0800, "light.spirited"
>>
>>>Hullo,
>>>I have just got myself a second hand kiln and it came with a few boxes
>>>of glazes. Quite a few of these glazes are completely dried out. Is it
>>>possible to rehydrate them?
>>>Thanks
>>>
>>
>> Most glazes are simply water-based suspensions. They should
>> rehydrate OK, but if they've solidified into a hard cake you may
>> have to break them up a bit. You'll want to sieve them after
>> you rehydrate. The idea here is not to block the chunks, it's
>> to give you a chance to work them around on the top of the
>> sieve with a brush until they dissolve and pass through.
>>
>> If you don't have a sieve yet, go down to your supermarket
>> and but one of those plastic coffee filters. The basket of
>> the ones I've seen (Ann Arbor, Michigan, USA) are brown,
>> with a nice taper that just fits into the top of a 16-oz yogurt
>> tub. The plastic mesh is 110 count, which is actually finer
>> than you really need (80 or even 60 is probably enough),
>> but it doesn't hurt... just takes a bit longer to get everything
>> through.
>>
>> Having said all that, however, I would caution that you check
>> these glazes very carefully. If they are really old, they will
>> almost certainly contain lead. If they are commercial glazes,
>> you may be able to find out about that from the makers if
>> you can read the numbers, colors, and types on the jars.
>> If there is any doubt, I'd err on the side of caution and
>> take them to the nearest toxic waste pickup station.
>>
>> Best regards,
>>
>>
>>
>> Bob Masta
>> dqatechATdaqartaDOTcom
>>
>> D A Q A R T A
>> Data AcQuisition And Real-Time Analysis
>> www.daqarta.com
>> Home of DaqGen, the FREEWARE signal generator
>
> You can heat up your water to make dissolving the material easier (If you
> have delicate coloring then use distilled water and heat on the stove - I
> just take it hot out of the pipes but I have good water). If the glazes
> are clearly labeled and you know the ingredients

To continue (I was rudely interrupted by a misplace send)... I agree with
Bob to put it shortly. If you don't know what your ingredients are (if the
glazes do not have ingredient labels or the person you bought it from cannot
tell you what is in the glazes, etc.) then I would not use them.

Donna



Posted by light.spirited on November 15, 2006, 11:36 pm
Please log in for more thread options
Thank you!!



light.spirited wrote:
> Hullo,
> I have just got myself a second hand kiln and it came with a few boxes
> of glazes. Quite a few of these glazes are completely dried out. Is it
> possible to rehydrate them?
> Thanks


Similar ThreadsPosted
Looking for GD glazes February 11, 2007, 1:47 pm
Disposing of Glazes November 15, 2006, 12:54 pm
Glazes - Randy's/Toby's Red September 2, 2006, 12:12 pm
^10 - light reduction glazes September 29, 2006, 10:44 pm
Crackle glazes? in layers? November 29, 2006, 6:11 pm
"Copper Red Glazes" book November 30, 2006, 8:40 am
Question about Fluorescent Glazes February 5, 2007, 4:41 pm
Spectrum Hi Fire Glazes March 2, 2007, 3:50 pm
liquid starch in glazes October 18, 2008, 5:50 pm
Low-fire lead-free glazes? September 24, 2006, 3:20 pm

The site map in XML format XML site map
Contact Us | Privacy Policy